Connecting Up



  1. Connect the UHF Aerial or Satellite dish cable from your wall port to the receiver.
  2. Connect the HDMI cable from the receiver to an HDMI port on your TV.
  3. Plug the receiver into a power socket and switch on at the wall.
  4. Insert the batteries into the remote control.
  5. Follow the On-Screen Instructions, on your tv.


Tip: If you have an ethernet cable handy, connect your receiver directly to your modem, or router for a reliable broadband connection.


Select Tuning Type

This receiver works with both UHF OR Satellite. During the initial setup you will be prompted to tune in the receiver



Use the < Left or > Right navigation arrows on the remote control, to select one of the following:

  • Select Terrestrial, if using a UHF Aerial.
  • Select Satellite, if using a Satellite Dish



To Retune the channels or change the tuning type at a later stage got to: Menu / Installation / Factory Reset.

To retune the channels or change the tuning type at a later stage, go to" Menu / Installation / Factory Reset.